Sealand DTM01C Tank Monitor Manual de usuario descargar pdf (Pagina 5)

1. Route 18-gauge stranded copper wire from DC Ground source to probe cap.

2. Using quick-disconnect terminals, make proper wiring connections from DC Ground source and

indicator panel to probe cap wires. Refer to wiring diagram (g. , page 4).

3. With probe cap removed from tank, turn on electrical power to system. Move black oat up and

down to assure proper operation of oat and indicator light. Red indicator light should

illuminate when oat is pushed up. After successful test, turn off electrical power and

disconnect wires at quick-connect terminals.

4. Install probe cap into 76 mm (3 in.) diameter port in top of holding tank. Tighten 1/4 turn beyond

hand tight. Re-connect wires and turn on electrical power.

6.2 Probe Cap (g. , page 2)

Dometic Tank Monitor Installation

Caution!

Do not use probe cap in fuel tank. Never install the probe cap with oat switch into a

tank that contains anything other than wastewater, gray water or fresh water.

Note

For installation in sailboats: Locate probe cap on athwartships centerline of tank to

assure accuracy when heeled.

1 2 3 4 5 6 7 8 9 10 ... 47 48

Sin comentarios

Sealand DTM01C Tank Monitor Manual de usuario Pagina 5