Sealand DVS02 Vacuum Status Control Manual de usuario descargar pdf (Pagina 10)

Operation Dometic Vacuum Status Control Panel

7 Operation

7.1 Vacuum status monitor (g.

, page 2)

1. WhenpowerswitchisturnedON,thegreen light indicates that there is sufcient vacuum in the

VacuFlushsystemtoushthetoilet(A).

2. WhenpowerswitchisturnedONandthered light glows, this indicates that there is NOT sufcient

vacuuminthesystemtoushthetoilet(B).Do not ﬂush toilet, or blockage may occur in system.

Notes

Ifgreenandredlightconstantlycycleonandoffbetweenushes,thereisapossible

vacuumleakinthesystem.(AnidleVacuFlushsystemshouldnotcyclemorefrequently

than once every three hours.)

If green light is ON but there is no vacuum in system, a blockage has likely occurred

betweenthetoiletandvacuumtank.Openushballintoiletbowlandusestandardtoilet

plunger to unblock.

After a period of time, if red light seems to remain lit longer than when toilet system was

new, duckbill valves in vacuum pump may require replacement.

Caution!

IfDVS02isconnectedtoa“fulltank”sensorandholdingtankisempty,acontinuousred

light may indicate extensive vacuum loss due to blockage, pump failure or leak. Turn off

vacuum system and repair as soon as possible.

7.2 “Full tank” monitor (onlywhen connected to “full tank” sensor in waste holding tank)

1. WhenpowerswitchisturnedON,theredlightglows,andthevacuumpumpisnotrunning,this

indicates that the holding tank is full and needs to be pumped out. Do not ﬂush toilet, or blockage

may occur in system.

7.3 Circuit breaker control (g.

, page 2)

1. TurnthepowerswitchtotheONposition(A,B)fornormaltoiletoperation.Onelightwillalwaysbelit

toindicatethereispowertotheVacuFlushtoiletsystem.Allowsystemvacuumtofullyrechargeand

green light to illuminate before turning power OFF for any reason.

2. Duringthenightorotherextendedperiodswhenthetoiletorvacuumsystemisnotneededto

operate,turnthepowerswitchtotheOFFposition(C).

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

Sealand DVS02 Vacuum Status Control Manual de usuario Pagina 10